52 206-4214
IP Environment Setup (Cont.)
Audio PTS Offset
Video PTS Offset
PCR Offset
IGMP Version
0
0
0
<>
<>
<>
Close
2
<>
IP Stream Control
If necessary, due to an audio and/or video stream delay, IP Stream Control options enable you to
compensate for synchronization irregularities by allowing audio PTS, video PTS, and PCR offset
modications. This menu also enables you to specify the IGMP version (2 or 3). Note that any
modications to these settings should be performed by qualied personnel only.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select IP Stream Control. Then, press OK.
2. In the IP Stream Control pop-up window, use the Up/Down arrow
keys on the Installer Remote to navigate to the appropriate eld:
Audio PTS Offset, Video PTS Offset, PCR Offset, or IGMP Version.
3. Use the Left/Right arrow keys to set the appropriate value for the
selected eld.
Note: Values represent offset time in milliseconds (ms) and can be
adjusted from -500 ms to +500 ms in 10 ms increments.
4. When you have completed all modications as required, either select
Close and then press OK on the Installer Remote or press to return
to the IP Environment Menu.
Network Status
Wired network is connected.
Complete
MAC Address : AA:BB:CC:DD:EE:23 Gateway : 10.10.10.10
IP Address : 10.2.3.4 DNS Server : 10.5.6.7
Subnet Mask : 255.255.255.0
TV Gateway DNS Internet
(Continued from previous page)
The TV will display a status screen as it conrms each of
the network elements, including the TV status, the gateway
status, the DNS status, and the Internet status (see example
at right). If the network is connected successfully, a “Wired/
Wireless network is connected” message will be displayed at
the top of the screen and the network conguration data will be
displayed in the lower half of the screen.
Note: If a problem is detected, the status screen will identify
the network element in which the connection failed. Check
cabling and/or conguration data, as necessary. If the status
screen is still on display, you can select Try again and press
OK to recheck the network status.
2. When the status screen shows that the network is connected,
select Complete (if not already selected) and press OK on the
Installer Remote to return to the IP Environment Menu.
Note: If you cancel the status check while it is in progress, the TV
will exit both the status window and the IP Environment Menu. If
you wish to return to the IP Environment Menu while the status
check is in progress, press on the Installer Remote.