RS-232C
26
External Control Device Setup

SET ID

How to connect external control equipment

*
Connect the RS-232C input jack to an external control device (such as a computer or a video control system)
and control the Projector’s functions externally.
MENU prev. move FGselect
Language
ARC
Flip Horizontal
Flip Vertical
Set ID
FG
1. Press the MENU button and then use F, Gbutton to select the menu.

2. Press the OK (A) button and then use D, Ebutton to select Set ID item.

3. Press the F, Gbutton to adjust Set ID to select the desired projector ID number.

●The adjustment range ofSet ID is 1~99.
●Only the projector with the specified ID number will operate from the remote control.
● To exit the menu display, repeatedly, press the MENUbutton.
English
FG
4 : 3
FG
1
•Connect the serial port of the PC to the RS-232C jack on the projector back panel.
•RS-232C cable is not supplied with the projector.
2
3
4
5
6
7
8
External
Device
RXD
TXD
DTR
GND
DSR
RTS
CTS
RXD 96
15
TXD
DTR
GND
DSR
RTS
CTS
Projector
* 1, 9 Pin No Connection
<Fig.1, RS-232 Interface Cable>
2
3
4
5
6
7
8
•Use the RS232C cable to control the projector externally (Refer to Fig.1).
Communication Parameter Setup
• Baud Rate : 115200 bps(UART)
• Data Length : 8 bit
• Parity : none
• Stop bit : 1 bit
• Flow Control : none
• Communication code : ASCII code