28INSTALLATION INSTRUCTIONS
Installation test (Duct check) (cont.)
• Check the error code before you call for service
Error Code | Possible Causes |
| Solutions |
|
|
|
|
tE1 or tE2 | • Temperature sensor failure | • Turn off the | dryer and call for |
| service. |
| |
|
|
| |
|
|
|
|
HS | • Humidity sensor failure. | • Turn off the | dryer and call for |
| service. |
| |
|
|
| |
|
|
| |
| • Electric dryer power cord is not | • Check the power supply or the | |
| connected correctly, or house power | connection of power cord to the | |
| supply is incorrect. | terminal block. Refer to the | |
|
| Connecting electric dryers section of | |
| • House fuse is blown, circuit breaker has | this manual for complete instructions. | |
PS or PF or nP | tripped, or power outage has occurred. | • Reset circuit breaker or replace fuse. | |
|
| Do not increase the fuse capacity. | |
|
| If the problem is a circuit overload, | |
|
| have it corrected by a qualified | |
|
| electrician. |
|
|
|
|
|
•Check the duct condition
If the test displays four bars, check the exhaust system for re- strictions and damage. Repair or replace the exhaust system as needed.
NOTE
When the dryer is first installed, this test should be performed to alert you to any existing problems with the exhaust duct in your home. However, since the test performed during normal operation provides more accurate information on the condition of the exhaust duct than does the installation test, the number of bars displayed during the two tests may not be the same.
Do not interrupt the test cycle, as this could result in the wrong results.
Even if no bars are displayed during the test cycle, some restrictions may still be present in the exhaust system. Refer to the Venting the Dryer section of this manual for complete exhaust system and venting requirements.
Your dryer features Flow Sense™, an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use.
Restricted or blocked airflow
Avoid long runs or runs with multiple elbows or bends.
Excess or crushed | Too many elbows or |
transition duct | exhaust too long |
Check for blockages and lint buildup.
Lint
buildup or
blockage
Make sure the ductwork is not crushed or restricted.
Crushed or
damaged
exhaust
