Common | LG Electronics F1256QD instruction

ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY

Rotor

Bolt

(ROTOR ASSEMBLY)

(1)

(STATOR ASSEMBLY)

Hinge,	Damper
Hinge,
Damper
	(DAMPER)

1Remove the BACK COVER.

2Unscrew the bolt to pull out the ROTOR assembly.

1Disconnect the wiring connector.

2Unscrew 6 bolts from the STATOR.

3Remove the STATOR.

Note : Hook of connector (1) is on the backside

1Pull out the hinge, pressing its snap.

2Do not use the pulled-out hinge again. It may be taken off during operation.

Motor Stator

U V W

•V ~ U (8~11Ω)

•U ~ W (8~11Ω)

•W ~ V (8~11Ω)

Hall Sensor

Hb

Ha

Common

•Common ~ Ha (5~15kΩ)

•Common ~ Hb (5~15kΩ)

40

Image 41

LG Electronics F1256QD service manual Rotor ASSEMBLY, Stator ASSEMBLY, Friction Damper Assembly, Common

Contents

Washing Machine No. MFL30574749 Contents F1*20TD1~9 / F1*22TD1~9/F1*56*D/WD-*690TDK Specification Features Features & Technical Explanation Door can not be Opened Determine Washing Time by Fuzzy LogicWater Level Control Power Plug Door Lower cover Adjustable FeetParts Identification Drawer Installation InstallationCheck the conditions of installation area Open the box and check appliance condition Tap connection and hose connection must be parallel Use spanner to remove transit boltsConfirm the distance between the appliance and the wall Connect Drain Hose Connect power plug Step Check the horizontality with a level Gage Test operation Operation Start/Pause button Tub CleanOption Wash program selector Time Delay & Beep ON/OFF Load Test ModePower button Water temperature selector Option button Start/Pause button Intensive Rinse Spin Button Motor Chart PCB Layout Program Chart Before Performing Service TroubleshootingLoad Test Mode HOW to Know the Water Level Frequency Error Symptom Cause Error Display Water Inlet Error IE Troubleshooting with Error Unbalanced Error UE How to disassemble and clean pump filter Water Outlet Error OE Bind Drawer continuously? Over Flow Error FE Pressure Sensor S/W Error PE Does the Door Switch operate as follows? Door Open Error dE MIN STD MAX Thermistor Heating Error tE Motor Locked Error LE Assemble the Hall Sensor Disassemble the Hall Sensor No Power Troubleshooting Without Error Codes Vibration & Noise In Spin Detergent & Softener does not flow Water Leak from Dispenser Water Leak Unknown Water on Floor Control Panel Disassembly Instructions Dispenser Assembly Dispenser Assembly Lower Cover Door Inlet Valve Gasket Assembly Common Rotor ASSEMBLY, Stator ASSEMBLY, Friction Damper Assembly Heater Pump When Foreign Material is Stuck Between Drum and TUB Switch ASSEMBLY, Door Lock Exploded View Exploded View of Control Panel & Dispenser Assembly Exploded View of Drum & TUB Assembly