Bind | LG Electronics F1256QD manual

Is the Standpipe Height greater than 1.0 m above the floor?

NO

When there is not water in the

YES

Observe Standpipe Height requirements of 1.0m maximum.

-Your washer will not be able to drain out water adequately, if the standpipe exceeds 1.0 m. In this case, water may flow back into the washer.

Check the Air Chamber and the Tube (clogged).

pump casing, is the water level frequency over 25.5KHz ?

YES

Is the Connector connected correctly to the Main PCB and the Pump Motor ? Or is the Harness alright ?

YES

Is the resistance of the Pump Motor out of 160 ~ 177Ω?

Or is there the Impeller bind?

Bind

OR

NO And When you check the water level frequency again, if it is over 25.5KHz, you replace the Pressure switch.

NO		Reconnect or repair the Connector.

		Or replace the Harness.

YES	Replace the Pump Motor.

NO

Is Pump motor started, when the spin	NO		Replace the Main PCB.


mode is started ?

24

Image 25

LG Electronics F1256QD service manual Bind

Contents

Washing Machine No. MFL30574749 Contents F1*20TD1~9 / F1*22TD1~9/F1*56*D/WD-*690TDK Specification Features Features & Technical Explanation Water Level Control Determine Washing Time by Fuzzy LogicDoor can not be Opened Power Plug Door Lower cover Adjustable FeetParts Identification Drawer Installation InstallationCheck the conditions of installation area Open the box and check appliance condition Confirm the distance between the appliance and the wall Use spanner to remove transit boltsTap connection and hose connection must be parallel Connect Drain Hose Connect power plug Step Check the horizontality with a level Gage Test operation Operation Start/Pause button Tub CleanOption Wash program selector Time Delay & Beep ON/OFF Load Test ModePower button Water temperature selector Option button Start/Pause button Intensive Rinse Spin Button Motor Chart PCB Layout Program Chart Before Performing Service TroubleshootingLoad Test Mode HOW to Know the Water Level Frequency Error Symptom Cause Error Display Water Inlet Error IE Troubleshooting with Error Unbalanced Error UE How to disassemble and clean pump filter Water Outlet Error OE Bind Drawer continuously? Over Flow Error FE Pressure Sensor S/W Error PE Does the Door Switch operate as follows? Door Open Error dE MIN STD MAX Thermistor Heating Error tE Motor Locked Error LE Assemble the Hall Sensor Disassemble the Hall Sensor No Power Troubleshooting Without Error Codes Vibration & Noise In Spin Detergent & Softener does not flow Water Leak from Dispenser Water Leak Unknown Water on Floor Control Panel Disassembly Instructions Dispenser Assembly Dispenser Assembly Lower Cover Door Inlet Valve Gasket Assembly Common Rotor ASSEMBLY, Stator ASSEMBLY, Friction Damper Assembly Heater Pump When Foreign Material is Stuck Between Drum and TUB Switch ASSEMBLY, Door Lock Exploded View Exploded View of Control Panel & Dispenser Assembly Exploded View of Drum & TUB Assembly