SMC Networks 10/100 manual 125, Syntax Switchport mode trunk access no switchport mode

VLAN COMMANDS

Example

The following example shows how to set the interface configuration mode to VLAN 1, and then assign an IP address to the VLAN:

Console(config)#interface vlan 1 Console(config-if)#ip address 192.168.1.254 255.255.255.0 Console(config-if)#

Related Commands

shutdown (3-96)

switchport mode

Use this command to configure the VLAN membership mode for a port. Use the no form to restore the default.

Syntax

switchport mode {trunk access} no switchport mode

•trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link between two switches, so the port transmits tagged frames that identify the source VLAN. However, note that frames belonging to the port’s default VLAN (i.e., associated with the PVID) are sent untagged.

•access - Sets the port to operate as an untagged interface. All frames are sent untagged.

Default Setting

All ports are in access mode with the PVID set to VLAN 1.

Command Mode

Interface Configuration (Ethernet, Port Channel)

3-125