SMC Networks 10/100 manual Command Usage

FLASH/FILE COMMANDS

Command Usage

•The system prompts for data required to complete the copy command.

•The destination file name should not contain slashes (\ or /), the leading letter of the file name should not be a period (.), and the maximum length for file names on the TFTP server is 127 characters or 31 characters for files on the switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)

•Due to the size limit of the Flash memory, the switch supports only one operation code file.

•The maximum number of user-defined configuration files depends on available memory.

•You can use “Factory_Default_Config.cfg” as the source to copy from the factory default configuration file, but you cannot use it as the destination.

•To replace the startup configuration, you must use startup-configas the destination.

•The Boot ROM image cannot be uploaded or downloaded from the TFTP server. You must use a direct console connection and access the download menu during a boot up to download the Boot ROM (or diagnostic) image. See “Upgrading Firmware via the Serial Port” on page B-1 for more details.

Example

The following example shows how to upload the configuration settings to a file on the TFTP server:

Console#copy file tftp

Choose file type:

1.config: 2. opcode: <1-2>: 1 Source file name: startup

TFTP server ip address: 10.1.0.99

Destination file name: startup.01 TFTP completed.

Success.

Console#

3-21