CONFIGURING THE SWITCH
Web – Click Port, Port Broadcast Control or Trunk Broadcast Control. Set the threshold for each port or trunk, and then click Apply.
CLI – Specify an interface, and then enter the threshold. The following sets broadcast suppression at twenty percent of the port bandwidth for Port 3.
Console(config)#interface ethernet 1/3 | ||
| ||
Console#show interface switchport ethernet 1/3 | ||
Information of Eth 1/3 |
| |
Broadcast threshold: Enabled, 20 percent |
| |
Ingress rate | limit: Disabled |
|
Egress rate limit: Disabled |
| |
VLAN membership mode: Access |
| |
Ingress rule: Disabled |
| |
Acceptable frame type: All frames |
| |
Native VLAN: | 1 |
|
Priority for | untagged traffic: 0 |
|
Gvrp status: | Disabled |
|
Allowed Vlan: | 1(u), |
|
Forbidden Vlan: |
| |
mode: NONE |
| |
| ||
mapping: NONE |
| |
Console# |
|
|
|
|
|
