BASIC CONFIGURATION
CLI – Specify the hostname, location and contact information.
Console(config)#hostname R&D 5 | ||
Console#show system |
| |
System description: TigerSwitch 10/100 - 6724L2 Managed 24+2 |
| |
| Standalone Switch |
|
System OID string: 1.3.6.1.4.1.259.6.10.42 |
| |
System information |
|
|
System Up time: 0 days, 1 hours, 1 minutes, and 41.64 seconds | ||
System Name | : R&D 5 |
|
System Location | : WC 9 |
|
System Contact | : Geoff |
|
MAC address | : |
|
Web server | : enable |
|
Web server port | : 80 |
|
POST result
UART Loopback Test | PASS | |
Flash Memory Checksum Test | PASS | |
CPU Self | Test | PASS |
MPC850 clock Timer and Interrupt TEST... | PASS | |
WatchDog | Timer and Interrupt Test | PASS |
DRAM Test | ............................... | PASS |
ACD Chip | Test | PASS |
Switch Driver Initialization | PASS | |
Switch Internal Loopback Test | PASS | |
DONE | ||
Console# |
|
|
|
|
|
Setting the IP Address
The IP address for this switch is unassigned by default. To manually configure an address, you need to change the switch’s default settings (IP address 0.0.0.0 and netmask 255.0.0.0) to values that are compatible with your network. You may also need to a establish a default gateway between the switch and management stations that exist on another network segment.
You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the configuration program.
