VLAN CONFIGURATION

Adding Static Members to VLANs (VLAN Index)

Use the VLAN Static Table to configure port members for the selected VLAN index. Assign ports as tagged if they are connected to 802.1Q VLAN compliant devices, or untagged they are not connected to any VLAN-aware devices. Or configure a port as forbidden to prevent the switch from automatically adding it to a VLAN via the GVRP protocol.

Notes: 1. You can also use the VLAN Static Membership by Port page to configure VLAN groups based on the port index. However, note that this configuration page can only add ports to a VLAN as tagged members.

2.VLAN 1 is the default untagged VLAN containing all ports on the switch, and can only be modified by first reassigning the default port VLAN ID as described under “Configuring VLAN Behavior for Interfaces” on page 2-65.

Command Attributes

VLAN – ID of configured VLAN (1-4094, no leading zeroes).

Name – Name of the VLAN (1 to 32 characters).

Status – Shows if this VLAN is enabled or disabled.

-Enable: VLAN is operational.

-Disable: VLAN is suspended; i.e., does not pass packets.

Port – Port identifier.

Trunk – Trunk identifier.

2-61

Page 93
Image 93
SMC Networks 10/100 manual Adding Static Members to VLANs Vlan Index