SMC Networks 10/100 manual Show snmp

SNMP COMMANDS

Default Setting

Issue authentication and link-up-down traps.

Command Mode

Global Configuration

Command Usage

If you do not enter an snmp-server enable traps command, no notifications controlled by this command are sent. In order to configure this device to send SNMP notifications, you must enter at least one snmp-server enable traps command. If you enter the command with no keywords, both authentication and link-up-down notifications are enabled. If you enter the command with a keyword, only the notification type related to that keyword is enabled.

The snmp-server enable traps command is used in conjunction with the snmp-server host command. Use the snmp-server host command to specify which host or hosts receive SNMP notifications. In order to send notifications, you must configure at least one snmp-server host command.

Example

Console(config)#snmp-server enable traps link-up-down

Console(config)#

Related Commands

snmp-server host (3-57)

show snmp

Use this command to check the status of SNMP communications.

Default Setting

None

3-59