COMMAND LINE INTERFACE

Command Usage

When auto-negotiation is enabled with the negotiation command, the switch will negotiate the best settings for a link based on the capabilites command. When auto-negotiation is disabled, you must manually specify the link attributes with the speed-duplexand flowcontrol commands.

Example

The following example configures Ethernet port 5 capabilities to 100half, 100full and flow control.

Console(config)#interface ethernet 1/5

Console(config-if)#capabilities 100half

Console(config-if)#capabilities 100full

Console(config-if)#capabilities flowcontrol

Console(config-if)#

Related Commands

negotiation (3-92) speed-duplex (3-90) flowcontrol (3-94)

flowcontrol

Use this command to enable flow control. Use the no form to disable flow control.

Syntax

flowcontrol no flowcontrol

Default Setting

Flow control enabled

Command Mode

Interface Configuration (Ethernet, Port Channel)

3-94

Page 236
Image 236
SMC Networks 10/100 manual Syntax Flowcontrol no flowcontrol Default Setting