Setup Checklist
Installation and configuration of the Free-To-Guest (FTG) Management Appliance (FMA-LG101) requires the following hardware, equipment, and software.
At the Head End
__ Contents of FMA-LG101 carton:
•FMA-LG101 unit (with attached rack mount brackets)
•Power supply (12V DC 1.25A)
•75 ohm coaxial terminator (FMA-LG101 RF IN port termination)
•7-foot Ethernet crossover cable (direct connect PC to configure FMA-LG101)
•50 MHz low pass filter (6MLP-50)
__ Configuration of the FMA-LG101 requires a PC with an Ethernet port and the FTG Device Configuration Application v5.0.0 or higher installed. FTG Device Configuration Application software is available online at: www.LGsolutions.com/ftgsoftware.
At the Room
__ An LG TV must be equipped with one of the following FTG devices:
•EBL (Embedded b-LAN™)
•LMT7Z9 MPI card
•LMT7Z7 MPI card (requires firmware update—see note below)
Note: Please contact the LG Sales team to obtain a Firmware Update (.mot) file. You can then use the Firmware Downloader Utility available from the FMA-LG101 software web page to upload the latest firmware to the FTG device(s). See Reference section, “FTG Device Firmware RF Downloader,” for detailed instructions.
Note: An HCS1410 FTG card is not compatible with the FMA-LG101.
