6To Install as a Slave Drive

To install the drive as a Slave, change the jumper setting on the rear panel to SL.

Connecting the Power Connector

Connect the power cable from the computer’s power supply to the socket on the drive unit,

fitting the connector firmly into the power in connector.If there is no spare power cable

available in the computer, you will have to purchase a splitter cable of a suitable type.

Connecting the Interface Connector

Connect the 40-pin IDE cable to the back of the Super Multi DVD Drive, making sure the

coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi DVD drive

(Pin 1 is closest to the Power Connector).

Slave drive
(Super Multi
DVD Drive)
(Jumper set to
Slave)
Master drive
(Booting hard disk)

- OR -

DIGITALANALOG
INTERFACEPOWER
DRCSM
SLA
GL
G3
9
1
+5+12
GND
40
2
AUDIOAUDIO
Primary
connector
Secondary
connector
Master drive
(Other IDE drive)
Slave drive
(Super Multi
DVD Drive)
(Jumper set
to Slave)
DIGITALANALOG
INTERFACEPOWER
DRCSM
SLA
GL
G39
1
+5+12
GND
40
2
AUDIOAUDIO
DIGITALANALOG
INTERFACEPOWER
DRCSM
SLA
GL
G39
1
+5+12
GND
40
2
AUDIOAUDIO
Master drive
(Booting hard disk)
AUDIO OUTSELECT
IDE INTERFACE CONNECTOR
INPUT
DC
39
401
25VGND12V
R GND L C.SEL
SLAVE
MASTER
5V GND 12V
CD INPUT

Beveled edge up

NOTE :Improper connection may damage

the drive and void the warranty.Generally,

the power connector can only fit one way.

AUDIO OUTSELECT
IDE INTERFACE CONNECTOR
INPUT
DC
39
401
25VGND12V
R GND LC.SEL
SLAVE
MASTER

Pin1

Red-edge

NOTE :Generally, the IDE connector is

keyed and will only fit one way.