MAINTENANCE
REPLACING OR REMOVING SCRUB BRUSHES
1.Turn the machine off.
FOR SAFETY: Before leaving or servicing the machine; stop on level surface, turn OFF machine.
2.Raise the scrub deck up by pushing down on the pedal.
3.Locate the brush reverse switch on the rear of the panel. Press to activate the motor then release to disconnect brush driver.
4.Tilt and pull machine back to expose brush driver.
INSTALLING SCRUB BRUSHES
1.Turn the machine off.
FOR SAFETY: Before leaving or servicing the machine; stop on level surface, turn OFF machine.
2.Tilt and push machine over brush driver. The brush centering bracket will position the brush driver.
3.Lower the scrub deck by pushing the pedal down and to the left.
4.Locate the brush switch and turn on.
SQUEEGEE BLADES
The front squeegee blade allows solution to pass through channels in the blade into the squeegee assembly while maintaining vacuum to provide lift.
The rear blade wipes the floor to a near dry condition. It is important the rear blade be in good condition to properly do its job.
Check both the front and rear squeegee blades for damage and wear each day in the
TO REMOVE SQUEEGEE ASSEMBLY
1.With the squeegee in the up position, turn the machine power off.
2.Loosen both squeegee knobs and pull squeegee assembly rearward from the lifting carrier.
3.Inspect or repair as necessary and reinstall.
TO REPLACE SQUEEGEE BLADES
1.With the squeegee in the up position, turn the machine power off.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine.
2.Remove the squeegee assembly from the machine. Remove all screws and remove blade retainer strap and remove squeegee blade.
3.Replace squeegee blades as required.
4.Install squeegee blade.
5.Install squeegee retainer strap.
6.Install all screws starting from center and working to ends.
86221970 17” SCRUBBER 01/03/07 |