Windsor 10052700 Controls, Brush Switch, BRUSH LIFT PEDAL Raises and lowers the brush, Hour Meter

Models: 10066210 10066270 10052700 SCH172 10066230 SCHC172 QSCC172 10066080 10066220 10066240 QSCC172IA HCC172 10066300 10066350 SCC172 10066260 10066310 10066250 10066320 10066330

1 24
Download 24 pages 58.04 Kb
Page 13
Image 13
2.BRUSH SWITCH

1.SOLUTION CONTROL LEVER Controls solution flow to scrub deck.

To increase flow push the knob forward to the desired flow.

To decrease flow pull the knob back.

2.BRUSH SWITCH

Controls the scrub brush motor.

To turn scrub brush on, press the top of the switch.

To turn scrub brush off, press the bottom of the switch.

3.BRUSH LIFT PEDAL Raises and lowers the brush.

To lower the brush, push down on pedal and move to the left.

To raise the brush, lift the lever from its lowered position.

4.VACUUM SWITCH Controls the vacuum motor.

To start vacuum motor, press the top of the switch.

To stop vacuum motor, press the bottom of the switch.

5.SQUEEGEE LIFT LEVER Raises and lowers the squeegee.

To lower the squeegee, lift and pull the lever to the right and then lower.

To raise the squeegee, lift the lever and push it to the left.

CONTROLS

6.BATTERY CHARGE LEVEL INDICATOR Indicates the charge level of the batteries.

The meter display is divided into 10 vertical bars. Bars illuminated on the top indicate full charge. Bars flashing near the bottom indicate the batteries should be recharged. Further operation of the machine could damage the machine or the batteries.

When the machine is left overnight with less than a full charge, the display may initially indicate a full charge. It will also indicate a full charge if the batteries are disconnected, then reconnected. After a few minutes of operation the meter will give the correct charge level.

7.HOUR METER

Records the number of hours the machine’s brush has been in operation. This information is useful in determining when to service the machine.

8.CIRCUIT BREAKERS

Circuit breakers interrupt the flow of power in the event of an electrical overload. When a circuit breaker is tripped, reset it by pressing the exposed button. If a circuit breaker continues to trip, the cause of the electrical overload should be found and corrected.

25 Amp. Protects the scrub brush motor.

25 Amp. Protects the vacuum motor.

9.BRUSH REVERSE SWITCH Reverses the scrub brush motor.

To activate, press the top of the switch.

86221970 17” SCRUBBER 01/03/07

3-6

Page 13
Image 13
Windsor 10052700 manual Controls, Brush Switch, BRUSH LIFT PEDAL Raises and lowers the brush, Hour Meter, Circuit Breakers