Installation
Installation
Select
the
Best Location
1.To prevent vibration and noise, make sure the unit is installed securely and firmly.
2.Install the unit where the sun does not shine directly on the unit.
3.The outside of the cabinet must extend outward for at least 12" and there should be no obstacles, such as a fence or wall, within 20" from the back of the cabinet because it will prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling effi- ciency of the air conditioner.
CAUTION: All side louvers of the cabinet must remain exposed on the outdside of the structure.
INSIDE OUTSIDE
FENCE
| AWNING |
COOLED AIR | HEAT |
| |
| RADIATION |
60" | ABOUT 1/4 " |
30"- | Over 20" |
|
4. Install the unit slanted slightly so the back is slightly lower | Figure 1 | |
than the front (about 1/4"). This will force condensed water | ||
| ||
to the outside. |
|
5.Install the unit with the bottom about 30"~60" above the floor level.
Installation Check
The setting conditions must be checked prior to initial starting.
The following items are especially important checking points when the installation is finished.
1.Grounding wire (Green or Green and Yellow) is provided in the power cord. The green wire must be grounded.
2.Connect to a
3.To avoid vibration or noise, make sure the air conditioner is installed securely.
4 Avoid placing furniture or draperies in front of the air inlet and outlet.
How
to
Secure the
Drain
Pipe
In humid weather, excess water may cause the Base Pan to overflow. To drain the water, remove the Drain Cap and secure the Drain Pipe to the rear hole of the Base Pan. (Figure. 2)
Drain Pipe | Drain Cap |
|
Figure 2
8Room Air Conditioner
