Troubleshooting Guide
COMPLAINT | CAUSE | REMEDY | |
|
|
|
|
Fan motor will not run. | No power | Check voltage at outlet. Correct if none. | |
|
|
|
|
| Power supply cord | Check voltage to Control Box. If none, check power | |
|
| supply cord. Replace cord if circuit is open. | |
|
|
|
|
| Wire disconnected or con- | Connect wire. Refer to wiring diagram for terminal | |
| nection loose | identification. Repair or replace loose terminal. | |
|
|
|
|
| Capacitor (Discharge | Test capacitor. | |
| capacitor before testing.) | Replace if not within ±10% of manufacturer's rating. | |
|
| Replace if shorted, open, or damaged. | |
|
|
|
|
| Will not rotate | Fan blade hitting shroud or blower wheel hitting | |
|
| scroll. Realign assembly. | |
|
| Units using slinger ring for condenser fan must have | |
|
| 1/4 to 5/16 inch clearance to the base. If it hits the | |
|
| base, shim up the bottom of the fan motor with | |
|
| mounting screw(s). | |
|
| Check fan motor bearings; if motor shaft will not | |
|
| rotate, replace the motor. | |
|
|
| |
Fan motor runs | Revolves on overload. | Check voltage. If not within limits, call an electrician. | |
intermittently |
| Test capacitor. | |
|
| ||
|
| Check bearings. Does the fan blade rotate freely? | |
|
| If not, replace fan motor. | |
|
| Pay attention to any change from high speed to | |
|
| low speed. If the speed does not change, replace the | |
|
| motor. | |
Fan motor noise. | Fan | If cracked, out of balance, or partially missing, | |
|
| replace it. | |
| Turbo | If cracked, out of balance, or partially missing, | |
|
| replace it. | |
| Loose clamper | Tighten it. | |
| Worn bearings | If knocking sounds continue when running or loose, | |
|
| replace the motor. If the motor hums or noise | |
|
| appears to be internal while running, replace motor. | |
|
|
| |
Compressor will not run, | Voltage | Check voltage. | |
but fan motor runs. |
| If not within limits, call an electrician. | |
|
|
| |
| Wiring | Check the wire connections, if loose, repair or | |
|
| replace the terminal. If wires are off, refer to wiring | |
|
| diagram for identification, and replace. Check wire | |
|
| locations. If not per wiring diagram, correct. | |
|
|
|
|
34Room Air Conditioner