LG Electronics LRE30757SW Maintenance, Removing &Replacing The Warming Drawer, Oven Vent, English

Models: LRE30757SB LRE30757ST LRE30757SW

1 40
Download 40 pages 8.73 Kb
Page 30
Image 30
MAINTENANCE

MAINTENANCE

REMOVING &REPLACING THE WARMING DRAWER

To Remove Warming Drawer:

1.CAUTION - Turn power OFF before removing the Warming Drawer.

2.Open the drawer to the fully opened position.

3.Remove the 2 screws (right and left sides). (refer to the drowing below)

4.Locate glide lever on each side of drawer, push down on the left glide lever and pull up on the right glide lever.

5.Pull the Warming Drawer away from the range.

English

WARNING

• Turn POWER OFF before removing the

 

 

Warming Drawer.

 

- Failure to do so can result in severe personal

 

injury,death or electrical shock.

Español

 

Remove screw

Lever

Lever

 

To Replace the Warming Drawer:

1.Replace shield on the right glide of the drawer body.

2.Pull the bearing glides to the front of the chassis glide.

3.Align the glide on each side of the drawer with the glide slots on the range.

4.Push the drawer into the range until levers click (approximately 2 inches). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers click or the bearing glides do not feel seated, remove the drawer and repeat steps 2-4.

This will minimize possible damage to the bearing glides.

OVEN VENT

The oven vent is located above the left rear surface unit. This area could become hot during oven use.

It is normal for steam to come out of the vent.

The vent is important for proper air circulation. Never block this vent.

Push down with finger

Pull up with finger

- 30 -

Page 30
Image 30
LG Electronics LRE30757SW Maintenance, Removing &Replacing The Warming Drawer, Oven Vent, To Remove Warming Drawer