LG Electronics LRE30757ST, LRE30757SW, LRE30757SB owner manual Care &CLEANING

Do not store a soiled broiler pan and grid anywhere in the range.

MAINTENANCE

CARE &CLEANING	Stainless Steel Surfaces (on some
Changing the Oven Light	models)
	Do not use a steel-wool pad; it will scratch the
The oven light is a standard 40-watt appliance bulb. It will	surface.
come on when the oven door is open. When the oven door is	1.	Shake bottle well.
closed, press OVEN LIGHT to turn it on or off. It will not	2.	Place a small amount of Stainless Steel Appliance Cleaner
work during the Self-Clean cycle.
		or polish on a damp cloth or damp paper towel.
To replace:	3.	Clean a small area, rubbing with the grain of the stainless
		steel if applicable.
• Make sure oven and bulb are cool.
	4.	Dry and buff with a clean, dry paper towel or soft cloth.
1. Unplug range or disconnect power.
	5.	Repeat as necessary.
2. Turn the glass bulb cover in the back of
	Note: If a mineral oil-based stainless steel appliance cleaner has
the oven counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.		been used before to clean the appliance, wash the surface
		with dishwashing liquid and water prior to using the
4. Replace bulb and bulb cover by turning clockwise.
		Stainless Steel Appliance Cleaner or polish.

5.Plug in range or reconnect power.

WARNING

•Before replacing your oven light bulb, DISCONNECT the electrical power to the range at the main fuse or circuit breaker panel.

-Failure to do so can result in severe personal injury,death or electrical shock.

•Make sure oven and bulb are cool.

WARNING

• DO NOT step or sit on the door and install the Anti-Tip Bracket packed with range.

- The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

- If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly reengaged when the range is pushed back against the wall.

Painted and Body Parts, and Decorative Trim

For general cleaning, use a cloth with hot and soapy water. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch.

Broiler Pan and Grid

Do not clean the broiler pan or grid in a self- cleaning mode.

After broiling, remove the broiler pan from the oven. Remove the grid from the pan. Carefully pour out the grease

from the pan into a proper container.

Wash and rinse the broiler pan and grid in hot water with a soap-filled or plastic scouring pad.

If food has burned on,sprinkle the grid with cleaner while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove burned-on foods.

Both the broiler pan and grid may be cleaned with a commercial oven cleaner.

Both the broiler pan and grid can also be cleaned in a dishwasher.

Oven Racks

Remove the oven racks before operating the Self- Clean cycle. Leaving the racks in place could cause

discoloration, and, if food is spilled into the tracks,

could causes the racks to

become stuck. If left, clean by using a mild, abrasive cleaner. Rinse with clean water and dry.

If the racks are cleaned in the Self-Clean cycle, their color will turn slightly blue and the finish will be dull. After the Self-Clean cycle is complete, and the oven has cooled, rub the sides of the racks with wax paper or a cloth containing a small amount of oil. This will make the racks glide easier into the rack tracks.

- 31 -

English

Español