LG Electronics LRE30757SW Glass surface—potentialfor, permanent damage, Heavy, Burned-OnResidue

MAINTENANCE

Heavy, Burned-On Residue

Glass surface—potential for

1.Allow the cooktop to cool.

2.Use the single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue.

Note: Do not use a

dull or nicked

blade.

permanent damage.

Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your cooktop (not covered by the warranty) unless the spill is removed while still hot.

Special care should be taken when removing hot substances. Be sure to use a new, sharp razor scraper.

3.After scraping with the razor scraper, spread a few drops of Ceramic Cooktop Cleaner on the entire burned residue area. Use the included Cleaning Pad to remove any remaining residue.

4.For additional protection, after all residue has been removed, polish the entire surface with included Cooktop Cleaner and a paper towel.

Metal Marks and Scratches

1.Be careful not to slide pots and pans across your cooktop. It will leave metal markings on the cooktop surface. These marks are removable using the Ceramic Cooktop Cleaner or included cleaner with the Cleaning Pad for Ceramic Cooktops.

2.If pots with a thin overlay of aluminum or copper are allowed to boil dry, the overlay may leave black discoloration on the cooktop. This should be removed immediately before heating again or the discoloration may be permanent.

Do not use a dull or nicked blade.

Damage from Sugary Spills and Melted Plastic

1.Turn off all surface units. Remove hot pans.

2.Wearing an oven mitt:

a.Use a single-edge razor blade scraper to move the spill to a cool area on the cooktop.

b.Remove the spill with paper towels.

3.Any remaining spillover should be left until the surface of the cooktop has cooled.

4.Don’t use the surface units again until all of the residue has been completely removed.

Note: If pitting or indentation in the glass surface has already occurred, the cooktop glass will have to be replaced. In this case, service will be necessary.

English

Español

CAUTION

•Cookware with rough or uneven bottoms can

mark or scratch the cooktop surface.

•Do not slide metal or glass across the cooktop surface.

•Do not use cookware with any dirt build up on bottom.

Cooktop Seal

To clean the cooktop seal around the edges of the glass, lay a wet cloth on it for a few minutes, then wipe clean with nonabrasive cleaners.

- 33 -