LG Electronics 37700H, 42700H LT2002 Cloning CONNECTIONS/LEARNING Setup, Before you begin cloning

COMMERCIAL MODE SETUP

LT2002 CLONING CONNECTIONS/LEARNING SETUP

Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup

Antenna

or CATV

Ferrite Core (TDK, ZCAT

2035-0930)	Connect cable to
	TV MPI Jack and
	follow on screen	Status
	instructions
	Indicator
	MPI
		Reset
		Color
	• green	battery ok
	• red	battery low
	Blink pattern
	• slow	power on
		no communications

• heartbeat power on communications ok

THE CLONE HAS CONTROL OF THE TV

THE CLONE IS VERSION		XX
THE TV IS VERSION		XX
THE SW IS REVISION		XX
CLONE CLOCK	= XX:XX
TV CLOCK	= XX:XX

-PRESS ANY KEY TO CONTINUE.

-DISCONNECT CLONE WHEN DONE.

Master TV

QuickSet II Programmer

LT2002

Clone Programmer

COMMERCIAL

Warning

G Do not use LT2002 while any PPV card is installed in TV or clone programmer device will be damaged.

!NOTE

G It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the signal

is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, see above and next page.

MODE SETUP

Before you begin cloning...

■The Master TV should be connected to a good, stable signal from an over-the-air antenna or cable service Analog channel and connected to power. (See above.)

■Teaching and Learning is only possible between iden- tical model devices. (However, the LT2002 Clone pro- grammer can store up to 3 different ‘master’ setups.) WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inopera- ble.

■Use an Installer’s remote to operate Learning and Teaching menus.

■Make sure that the batteries in the Clone programmer are fresh.

■If batteries are removed, the Clone Clock time will be lost.

■Decide if you want to set the time from the Clone programmer or copy the time to the Clone program- mer; from a compatible TV which has the clock set to the current time.

■Setting the time and transferring it to the Clone or other device is a separate procedure.

■Follow the connection diagram above to connect the Clone to a Master TV TV display panel. After learning is complete, to another identical TV TV display panel to “teach” it the master setup.

■See the Clone Troubleshooting section to resolve problems.

Turn to the next page to continue Cloning Setup.

92