LG Electronics 37700H, 42700H Reference LT2002 Cloning Procedure Troubleshooting, Than 30 seconds

APPENDIX

REFERENCE: LT2002 CLONING PROCEDURE TROUBLESHOOTING

Warning: Do not use LT2002 while any PPV card is installed in TV or clone programmer will be damaged.

Reset Clone After Static Shock

After replacing exhausted batteries, or if the program- mer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked ”RESET” to activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV con- taining the correct time.

Note

The LT2002 programmer is designed to be used with TVs containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. Processors used before the 221-01006-04 have a lim- ited screen display capability. They cannot display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your pro- gramming choices. (Although the menus are not all dis- played, the clone functions all operate normally.)

Clone Programmer Troubleshooting

Clone Programmer

Clone copies Setup in less

than 30 seconds

Remote does not operate

clone

LED does not blink

■Press Reset on clone programmer, redo teach/learn. (Teach/Learn should take a minimum of 1 minute.)

■Only32LG3DCHuse an LG Installer remote to operate clone programmer with TV.

(32LG3DCH-UA)

■Connect M.P.I. cord properly, assure good connection.

■TV must be powered On for clone to work.

■Install 4 fresh AA high-quality alkaline batteries.

APPENDIX

Clone menu hard to read

No time set

Clone not working

Clone Scans Channels

more than once

Master and Other TVs

Cloning did not work

■ Connect TV to a reliable Analog channel signal source.

■ Set time on a TV, copy time to Clone Programmer.

■ Try a different LT2002 Clone programmer.

■ Reset Clone Programmer.

■ Retry cloning again.

■ Wait until procedure complete message is displayed.

■ Cloning is only possible with identical model TVs.

■ Reread cloning pages to be sure all tasks were performed.

32LG3DCH

(32LG3DCH-UA)

Clone time disappeared ■ Batteries must remain installed to retain time settings.

New Setup not present ■ Disconnect newly-cloned TV from power for 5 seconds.

■After cloning operations are complete, just unplug the LT2002 from the TV.

■If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.

108