![](/images/new-backgrounds/1133556/13355679x1.webp)
Commercial Mode Setup for Master STB1000
This section describes how to set up a Master STB1000 when the EBL is in
Note: Disconnect all Aux inputs. Under certain conditions, Auto Tuning (Channel Search) is disabled if there is an Aux input active.
Note: Refer to “FTG Mode of Operation” on pages 58 to 61 for information on configuring/editing FTG Channel Map and Installer Menu settings for an individual STB1000 in FTG Mode.
1.Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 43 to 48 for detailed information on all Installer Menu items.
a)Make sure the STB1000/display panel is ON. Then, use the Installer Remote to enter the STB1000 Installer Menu: Press MENU repeatedly until the
b)Set Installer Menu item 117 FACT DEFAULT to 001 and press ENTER on the Installer Remote.
This exits the Installer Menu and then clears all Installer Menu custom settings, channel labels/icons, etc. and reloads the factory default settings. The value will change back to 0 after the internal STB controller (Protocol Translator Card [PTC]) has been restored to factory default condition. This step ensures that the STB Channel Memory will be the active channel lineup.
c)
•Broadcast: Set to 000.
•CATV: Set to 001 (default).
•HRC: Set to 002.
•IRC: Set to 003.
d)Set any other Installer Menu items that affect your TV program- ming network to the required configuration. For example, enable/ disable Aux sources, set a Start Channel, etc.
e)After you have adjusted all required Installer Menu item settings, press ENTER once on the Installer Remote to save your changes; then, press ENTER again to exit the menu.
2.Set up display features.
Note: If desired, you can run Auto Tuning (see step 3) prior to completing this step.
LODGING PTC INSTALLER MENU
| 000 | INSTALLER SEQ | 000 |
|
|
|
|
|
|
| UPN | ASIC 20E7 |
| |
| PTC | V1.00.00 | STB V3.00.00 |
|
| Typical STB1000 Installer Menu |
| ||
|
|
|
| |
117 | FACT DEFAULT | 001 |
| |
|
|
|
| |
003 | BAND/AFC | 00X |
|
Adjust the settings for these
Installer Menu items.
CHANNEL | PICTURE | AUDIO | TIME |
OPTION | LOCK | INPUT | USB |
Set the display features to the desired
configuration for the end user.
(Continued on next page)
40 |