Basic Phone Operation
|
| Turning the Phone On and Off | |
I n t r o | |||
Turning the Phone On | |||
d u c t | |||
1) Install a charged battery pack or connect the | |||
i o n | phone to an external power source such as the car | ||
kit or AC Adaptor. |
|
2) Hold down the Key | for 2 seconds until the |
LCD screen flashes. |
|
Note As any other communication device, avoid any unnecessary contact with the antenna while your phone is turned on.
Making a Call
Every time you make a call, follow these steps:
1) Make sure that the phone is turned on. If not, hold
down | for 2 seconds. |
|
|
2) Type the phone number and then press | . | ||
▶ If the phone is locked, type the lock code |
| ||
3) To end the call press | . |
| |
Note In no service area, 
appears from the screen. When trying voice call in no service area,
“Out of Service area”is displayed. It means you are in no service area.
Receiving Calls
1)When the phone rings or vibrate (if the Vibrate
Mode is enabled), press any key (except 
) or
depending on the Call settings.
▶When you press 
once, when a call is received, the phone stops ringing or vibrating depending on the mode it is in.
2)To end an answered call press 
.
On pressing the 
key for the first time, when the call is received, the phone stops ringing or
vibrating depending on the mode it is in. Pressing
key after that will disconnect the call.
Signal Strength
If you’re inside a building, being near a window may give you better reception. You can see the strength of
your signal by the signal indicator ( 
) on your phone’s display screen.
About the antenna
Your phone has a
touch the antenna unnecessarily when the phone is switched on.
Contact with the antenna affects
call quality and may cause the phone to operate at a higher
power level than needed. Not touching the antenna during a call optimizes the antenna performance and the
Quick Adjust
Adjusting Vibrate Mode
Use Vibrate Mode in a public place.
1)In standby mode, activate Vibrate Mode quickly by
pressing the 
. (for 2 seconds) instead of using the Menu function.
▶When Vibrate Mode is set, Key tone does not sound.
Basic Phone Operation
Note To cancel Vibrate Mode, press for 2 seconds.
Select Profiles |
| I n t r o |
1) In standby mode, press . |
| d u c t |
2) Select one of four Profiles Silent Mode, Vibrate | i o n | |
Mode, User Mode and Power Mode with | . |
|
3) Press | . |
Adjusting Speaker Mode On
During a call, to activate or cancel Speaker quickly, press 
.
Adjusting Keypad Lock Function
Used to lock the keypad and prevent accidental pressing of the keys. There are two ways to enable the Keypad Lock Function - with one key and by using the Menu.
1)In standby mode, set the Key Guard to be enabled
by pressing and holding the key 
about 2 seconds.
Note To cancel the Keypad Lock Mode, Press Soft
Key 1, then press the star (*) key.
14 | 15 |
