Liebert GXT2-6000RTL630 5.2 Install the Internal Batteries

Installation and Configuration

7. Insert the equipment, with inner members attached in

Step 5, into the bracket assemblies by inserting the top

and bottom edges of the inner members into the top and

bottom curved tracks of the front members and sliding

the equipment into the rack (see figure at right). Ends of

inner members are tapered to allow the rear of the

equipment to be angled upward before insertion, if space

allows.

Then the rear, bottom edges of the inner members can

be placed into the front edge of the bottom tracks and

the front of the equipment can be tipped up so they are

level to insert the top edges of the inner members before

sliding the equipment into the rack (see figure below

right). The equipment should move smoothly into the

bracket assemblies. If it does not, recheck the alignment

of the front and rear members from Steps 2 and 3.

8. Secure the front of the equipment to the rack mounting

rails to prevent the equipment from sliding out of

position. If securing holes are provided on the front of

the equipment that align with the center holes on the

return flange of the front members, you can use the four

(4) extra M5 screws provided in the kit to secure the

equipment. Otherwise, the equipment should be secured

to the front of the rack with four (4) customer-supplied fasteners.

5.2 Install the Internal Batteries

For ease of installation and configuration, the GXT2-6000RTL630 is shipped without its internal bat-

teries installed. After the UPS is prepared and installed as either a tower or in a rack, install the

GXT2-240BATKIT battery packs.

To install the internal batteries:

!CAUTION

A battery can present a risk of electrical shock and high short circuit current. Observe the

following precautions before replacing the batteries:

• Remove rings, watches and other metal objects.

• U se a Phillips (cross-head) screwdriver with insulated grips.

• Do not lay tools or other metal objects on top of the batteries.

• If the battery replacement kit is damaged in any way or shows signs of leakage, contact

your local dealer or Liebert representative immediately.

• Do not dispose of batteries in a fire. The batteries may explode.

• Do not open or mutilate batteries. Released electrolyte is harmful to the skin and eyes. It is

toxic.

Insert the UPS into the front

members, lift the front ...

... and push it

into the rack.

UPS or

battery

cabinet

Apply

grease

(inside)

grease