Installing the Card
The OpenComms Web Card is hot swappable and user-serviceable.
Although you do not need to turn off the UPS, disconnect any loads, or
restart the UPS to install or remove the card, discretion should be used.
CAUTION: The Intellislot Bay is located in close proximity to the UPS'
output and the UPS' electrical receptacles. Whenever possible, you
should turn the UPS OFF when installing the card.
To install the card:
1.Locate the Intellislot bay on the back of the UPS. For Nfinity, use the
Intellislot labeled "1".
2.Remove the plastic Intellislot cover and save the screws for Step 4.
3.Insert the OpenComms Web Card into the Intellislot bay.
4.Secure the card with the screws you removed in Step 2.
NOTE: The card is powered by the UPS during both normal and on bat-
tery operation. If the UPS is ON, the card will operate normally after a
brief boot up period.
Connecting the Card to the Network
To connect the card to the network, simply plug an Ethernet cable to the
RJ-45 connector on the card.
The card support 10Mbit and 100Mbit communication speeds at either
half or full duplex. The card ships from the factory in an auto-sensing
mode. In this mode, the card works to negotiate the optimal setting for
your network environment. To turn off the auto-sensing mode and force
the card's communication speed or duplex setting, you will need to open a
Service Terminal connection to the card. Please refer to the Service Ter-
minal section.
Configuring the Card
The card ships from the factory with DHCP service enabled. The MAC
address is located on a sticker affixed to the top of card. To give the card
a Static IP address, you will need to open a Service Terminal Connection
to the card. Refer to the Service Terminal section for more details.