Putting into operation
-the freezer temperature is above 0 °C.
The following displays indicate malfunction. Possible causes and corrective action (see Malfunction).
-F0 to F9
-FE*
-The power failure symbol 
shines.
4 Putting into operation
4.1 Switching on the appliance
Note
u To switch on the entire appliance it is necessary only to switch on the freezer compartment.
Switch on the appliance approx. 2 hours before adding frozen food for the first time.
Do not load food to be frozen before the tempera- ture display reads
4.1.1 Switching on the freezer compartment
uOpen the door.
uPress On/Off button, freezer compartment Fig. 2 (8).
The temperature display of the refrigerator compartment indicates the current temperature inside.
The temperature display of the freezer compartment and the alarm symbol flash until the temperature is sufficiently low. If the temperature is above 0 °C, dashes flash. If it is below,
the current temperature flashes.ww
4.1.2Switching on refrigerator and BioFresh compartment
If the refrigerator compartment was switched off (e.g. during an extended absence like holidays), it can be switched back on separately.
u Open the door.
u Press On/Off button, refrigerator compartment Fig. 2 (1). w The interior light is on when the door is opened.
w The temperature display shines. Refrigerator and BioFresh compartment are switched on.
5 Control
5.1 Child proofing
The
5.1.1 Setting the child lock function
u To activate the setting mode: press SuperFrost button Fig. 2 (12) for about 5 s.
w c flashes on the display.
w The menu symbol Fig. 2 (16) shines.
u Briefly press the SuperFrost button Fig. 2 (12).to confirm. When c1 is indicated in the display:
u Tto activate the child lock, briefly press the SuperFrost button Fig. 2 (12).
wThe child lock symbol Fig. 2 (17) shines. c flashes in the display.
When c0 is indicated in the display:
u to deactivate the child lock, briefly press the SuperFrost button Fig. 2 (12).
wThe child lock symbol Fig. 2 (17) goes out. c flashes in the
display.
u To deactivate the
u Wait for 5 minutes.
w The temperature is indicated again in the temperature display.
5.2 Door alarm
For refrigerator/BioFresh compartment and freezer compart- ment
If the door is open for longer than 60 seconds, the audible warning will sound.
The audible alarm is automatically silenced when the door is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The sound
u Press alarm button Fig. 2 (14). w The door alarm is silenced.
5.3 Temperature alarm
The audible alarm sounds if the freezer temperature is not cold enough.
The temperature display and the alarm symbol Fig. 2 (15) flash at the same time.
The cause of the temperature being too high may be:
-warm fresh food was placed inside
-too much warm ambient air flowed in when rearranging and removing food
-power failure for some time
-the appliance is faulty
The audible alarm is automatically silenced, the alarm symbol Fig. 2 (15) goes out and the temperature display stops flashing when the temperature is sufficiently cold again.
If the alarm status persists: (see Malfunction).
Note
Food may be spoilt if the temperature is not cold enough.
u Check the quality of the food. Do not consume spoiled food.
5.3.1 Muting the temperature alarm
The audible alarm can be muted. When the temperature is sufficiently cold again, the alarm function is active again.
u Press alarm button Fig. 2 (14). w The audible alarm is silenced.
5.4 Refrigerator compartment
The natural circulation of air in the refrigerator compartment results in zones differing in temperature. It is coldest directly above the plate separating off the BioFresh zone and at the rear wall. It is warmest at the top front of the compartment and in the door.
* Depending on model and options | 5 |
