Liebherr 7083 247-00 Changing over door hinges, Installation dimensions mm, Version

Mount door on hinge pin and close.

Changing over door hinges

1.Unscrew the hinge bracket.

Important: The door mounting has a spring mechanism enabling the door to close by itself. The hinge bracket turns to the left when the screws are undone.

2.Pull the door out at the bottom and lift off.

3.Transfer handle and plugs to the opposite side of the door.

4.Transfer pin on hinge bracket to the opposite side.

5. Transfer upper hinge components to the opposite side.

6. Transfer cover plate to the opposite side.

7.

8.Insert hinge bracket in lower door mounting.

9.Turn hinge bracket by 90° - spring is compressed. Screw on hinge bracket.

GB

Installation dimensions (mm)

Version 1

A cross-section of min. 200 cm2 is required­ in the worktop for ventilation of the rear of the appliance.

Version 2

If no ventilation grille is provided in the worktop, the recess must be at least 860 mm high to ensure adequate heat dissipation to the front.

The appliance complies with the relevant safety regulations and EC Directives 2004/108/EC and 2006/95/EC.

25