Cleaning
Before cleaning always switch off the appliance. Disconnect from the mains or switch off or unscrew the fuse.
•Clean the inside, equipment and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents.
Do not use steam cleaners because of the
risk of injury and damage.
•Ensure that no cleaning water penetrates into the electrical com- ponents or ventilation grille.
•The dust should be removed from the refrigeration unit and heat exchanger - metal grid at the back of the appliance - once a year.
•Do not damage or remove the type plate on the inside of the ap- pliance. It is very important for servicing purposes.
GB
Opening for external temperature sensor
1. Drill marked section on the back of the appliance.
Malfunctions
You may be able to rectify the following faults by checking the possible causes yourself:
• Appliance does not function: | |
– Is the appliance switched on? | |
– Is the plug correctly fitted in the mains socket? | |
– Is the fuse intact? | |
• Loud running noise: | |
– Is the appliance set up firmly on the floor? | |
– Does the appliance cause nearby items of furniture or objects to | |
| vibrate? Please note that noises caused by the refrigerant circuit |
| cannot be avoided. |
• The temperature is not low enough: | |
– Is the temperature setting correct (see "Setting the temperature")? | |
– Does the separately installed thermometer show the correct read- | |
| ing? |
– Is the ventilation system working properly? | |
– Is the appliance set up too close to a heat source? | |
• | appears in the display: |
– Reset the real time clock (see "Setting the real time clock").
If none of the above causes apply and you cannot rectify the fault yourself, contact the near- est customer service depart-
ment stating the type designa- tion 1, service number 2and appliance number 3 as indi- cated on the type plate.
The position of the type plate is shown in the section entitled Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or switch off or unscrew the fuse. Clean the appliance and leave the door open in order to prevent unpleasant smells.
2. Pull out strain relief device (bot- tom left of interior container).
3.Feed sensor through opening and secure sensor cable with strain relief device.
Important!
Position the sensor at the top of the interior container. The sen- sor must not come into contact with objects so that only the air temperature is measured.
Important!
4. Close the sensor cable opening at the back of the appliance with the sealant provided.
23
