|
| CAUTION |
| identifies a dangerous situation |
|
|
|
|
| which, if not obviated, may result in |
|
|
|
|
| minor or medium bodily injury. |
|
|
|
|
|
|
|
|
| NOTICE |
| identifies a dangerous situation |
|
|
|
|
| which, if not obviated, may result in |
|
|
|
|
| damage to property. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Note |
| identifies useful information and tips. |
|
|
|
|
|
|
|
(1) | On/Off button, refriger- | (6) | Fig. 3 |
Setting button, freezer | |||
(2) | ator compartment | (7) | compartment |
Fan button | SuperFrost buttont | ||
(3) | Setting button, refriger- | (8) | Alarm button |
(4) | ator compartment | (9) | On/Off button, freezer |
Refrigerator compart- | |||
| ment temperature |
| compartment |
(5) | display |
|
|
Freezer compartment |
|
| |
| temperature display |
|
|
The following are displayed in normal operation:
-the set freezing temperature
-the set cooling temperature
The freezer compartment temperature display flashes:
-the temperature setting is being changed
-after
-the temperature has risen several degrees
Ensure that the following tools are to hand: q Torx 25
q Torx 15
qScrewdriver
qCordless screwdriver, if necessary
qSecond person for fitting work, if needed
Note
u Remove any food from the door racks before removing the door, so that no food falls out.
Fig. 4
uClose the upper door.
uPull off the cover Fig. 4 (1) forwards and upwards.
uLift off the cover Fig. 4 (2)
CAUTION
Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.
u Unscrew the upper turn hinge Fig. 4 (3)(2 Torx 25) Fig. 4 (4) and raise it for removal.
u Lift up the upper door and set it aside.
uClose the lower door.
uDraw the middle bearing pin Fig. 5 (11) out of the turn hinge and lower door.
uRemove the plastic cap Fig. 5 (10).
CAUTION
Risk of injury if the door tips! u Take good hold of the door. u Set down the door carefully.
u Open the lower door.
u Detach the middle turn hinge Fig. 5 (13). u Lift up the door and set it aside.
Fig. 5
uCarefully detach the cover panel Fig. 5 (12).
uTurn the middle turn hinge Fig. 5 (13) through 180° and screw it firmly into place on the new hinge side (with 4 Nm).
uTurn the cover panel Fig. 5 (12) through 180° and snap it into place again on the new handle side.
4