Control
uUse the front area of the refrigerator compartment floor only for briefly putting down cooled products, e.g. when rear- ranging and sorting. However do not leave cooled products there otherwise they may be pushed back or tipped over when the door is closed.
uDo not store food too close together to enable good air circu- lation.
uTo safeguard bottles from tipping over: move the bottle holder.
The temperature depends on the following factors:
-the door opening frequency
-the room temperature at the site where the appliance is installed
-the type, temperature and quantity of frozen food
Temperature setting to be recommended: 5 °C
The temperature can be changed continuously. Once the 1 °C setting is reached, it starts again with 9 °C.
u To access temperature adjustment: press the setting button, refrigerator compartment Fig. 3 (3) once.
u Press the setting button, refrigerator compartment Fig. 3 (3) the number of times needed until the required temperature shines in the LED display.
Note
u Long pressing of the setting button sets a slightly colder value within a small temperature range (e.g.: between "5" and "7"), but it is not visible in the display.
With the fan you can rapidly cool large quantities of fresh food or achieve a relatively even distribution of temperature across all the storage levels.
The
-at high room temperature (from approx. 30 °C )
-at high humidity
The
uBriefly press the fan button Fig. 3 (2). w The fan button shines.
w The fan is active. It switches on automatically when the compressor runs.
uBriefly press the fan button Fig. 3 (2). w The fan button goes out.
w The fan is switched off.
The shelves have stops preventing them from being unintention- ally pulled out.
u Lift the shelf and draw it out forwards.
u Insert shelf with the raised edge pointing upwards at the back. w The food does not freeze onto the rear wall.
Fig. 10
uThe glass shelf with stop face (2) has to be at the back.
*
u Remove storage rack according to illustration.
*
The boxes can be removed and placed on the table as a single unit.*
Only one box or both boxes can be used. If particularly tall bottles are to be stored, attach only the wide box above the bottle rack.*
Three small boxes are available through the customer service as optional equipment instead of one wide and one small box.* u
removal and
*
u To detach lid: Open 90° and raise to disengage.*
*
u Always take hold of the bottle holder on the plastic part.
8