Liebherr EWTN installation instructions Reversing Door Hinges, A delight in freshness

REVERSING DOOR HINGES

12.Figure 13: Lift up cover (3) on handle side, push outward; lift up cover (1) on hinge side and pull off.

13.Unscrew mounting plate (21): first mounting screw (20), then inner retaining screw (25).

-Unscrew hinge (4): first remove the mount- ing screw (20), then retaining screws (25). Fit hinge (4) to opposite side: for easy assem- bly, fit hinge from above and first tighten with the upper retaining screw (25) M5, then screw (25) and finally mounting screw M4 (20).

-Turn mounting plate (21) 180° and screw tight again on the new handle side: first retaining screw (25), then mounting screw (20).

14.Remove the eccentric (5) with the retaining screw in the hinge (4).

15.On the upper door: Reinstall the door fittings (16, 17). Pay special attention to the fitting (17) with the stop.

16.Place the upper door on the center hinge, fit the bushing (8), stop (7) and washer on the door, swivel in the door at the top and insert and secure the hinge pin (2) from above through the hinge and stop.

17.Re-insert the eccentric (5) with the retaining screw as shown in the detailed drawing.

Check for proper alignment of all doors. Adjust them if necessary using the slots on the hinge.

4				21
20 25			°	25	20
		0
	8
	1
21				4		12
				14

15

17

16

15

Figure 13

A delight in freshness

16 WFI1051 / EWTN 2956