Liebherr EWTN Icemaker, Connection to the Water Supply, A delight in freshness

ICEMAKER

Connection to the Water Supply

1.Install the shut-off valve, water filter and auto- matic shut-off device as required.

Note

The solenoid valve is located at the rear of your unit.

2.Place a 1/4" OD copper tubing between the shut-off valve and solenoid valve. Make sure there is approximately 30" (70 cm) of excess tubing behind the unit for easy connection.

IMPORTANT

The solenoid valve has a Metric R3/4 male connection.

A R3/4(metric) to a 1/4" OD adapter and cable clip are supplied with the icemaker.

Figure 24: Remove the cover cap (4) from the solenoid valve (1). Install the connection bracket (2) with sealing ring (6) on the solenoid valve (1). Attach the copper tube to the connec- tion bracket (2). Secure the copper tube (3) to the appliance using the cable clip (5).

3.Open the shut-off valve for the water supply and check the entire water system for leaks. Before the appliance is used for the first time a licensed plumber should bleed air from the sys- tem.

4.Insert the electrical plug for the combined appli- ance into the electrical outlet (Figure 23).

5.Move the appliance into final position in the room.

Figure 23

A delight in freshness

24 WFI1051 / EWTN 2956