Liebherr EWTN Installation, A delight in freshness, The following ventilation cross-section

INSTALLATION

The following ventilation cross-section

and distances must be observed:

-There must be a ventilation space of at least 31 square inches (200 cm²) per appliance in the cabinet plinth and under the cabinet top panel.

-The depth of the ventilation duct at the rear of the cabinet must be at least 1-1/2" (38 mm).

Alternatively:

1.For built-in appliances without ven- tilation grilles and only with an instal- lation frame, ventilation must take place through the ventilation duct at the rear of the cabinet.

Built-in appliances with an installation frame:

•Figure 19:

-Screw the complete installation frame (2) to the appliance.

	1		1/2”
38
(		mm)

At least 31 square inches (200cm2 )

			”
		/4			)
	3			m
0
2			m
		7
	2
5
(

1

2

1

2.Built-in appliances with a wooden ventilation grille:

Figure 20: Cut out the wooden trim for use as a ventilation grille using the enclosed template.

-The required ventilation cross-sec- tion must be at least 31 square inches (200 cm²) when a single appliance is installed, which cor- responds to template “small” (If you install two appliances side-by-side, the cross-section must be at least

62 square inches, (400 cm²), which corresponds to template “double- size;” for more information see “Side-

by-Side Installation”).

•Remove the attachment bracket (2) from the installation frame and screw it to the appliance (1) from underneath. Place the wooden ventilation grille (5) on the appliance, align it in the center and secure it from the rear using the attachment bracket (2).

Figure 19

2	1/2"
5
	(13 mm)
1
24"
(609,6 mm)
3-11/16"
(93,7 mm)

Figure 20

A delight in freshness

20 WFI1051 / EWTN 2956