Life Fitness Fit-1 manual Button Head

STEP 18:
•	Slide two 5” ACCORIDIAN SLEEVES	36
	(36) over the shafts on the PIVOT ARM
	(9) as shown in FIGURE 18.	37
•	Slide two PILLOW BLOCKS (37) over
	the shafts on the PIVOT ARM (9) as
	shown in FIGURE 18.
		9
		FIGURE18
		4

3/8 X 3” (76m) 72

BUTTON HEAD

74
35	37		9
		75	78
	3	76	73

FIGURE 19

STEP 19:

•SECURELY assemble the PILLOW BLOCKS (37) on the PIVOT ARM (9) to the LEFT and RIGHT BOOM SUPPORTS (3 & 4) using four 3/8 X 3” BUTTON HEAD BOLTS (72), four BLACK 3/8” SAE WASHERS (74), four RH WASHERS (76), four 3/8” SAE WASHERS (75), four 3/8” LOW HEIGHT LOCK NUTS (73) and four RH CAPS (78) as shown in FIGURE 19.

•IMPORTANT! When PIVOT ARM (9) is centered and level in the PILLOW BLOCKS (37), tighten the PILLOW BLOCK set screws.

•Slide two 1-3/8” OD COVER CAPS (35) over the ends of the shaft on the PIVOT ARM (9) as shown in FIGURE 19.

0	1/2		1	1/2	2		1/2	3		1/2	4		1/2	5		1/2	6
	10	20	30	40	50	60		70	80	90	100	110		120	130	140	150

15