Lifebreath 4TONDHW(T), 60DHW(T), 60VENTAC, 60DHWH(T) Electrical, Clean Air Furnace - Wiring Diagram

Electrical

The Clean Air Furnace operates at 120V, singles phase and draws anywhere from 2-8.7 amps, depending on fan speed.

The low voltage thermostat (not provided) connects to the R & W terminals for heating and the R & Y & C terminals when calling for cooling.

Caution should be used if installing a setback thermostat to control the system. If the thermostat is set back too far, and, for example, is set to call for a lot of heat when you get out of bed, at which time showering and general water use is at its peak, then the hot water heater may not keep up.

	Clean Air Furnace - Wiring Diagram
R - W	= Heat
R - G	= Fan Only (optional dehumidistat)
G - R - Y - C	= A/C

OPTIONAL PUMP TIMER

1 LOAD 4
2 LINE	5
3 NEUT.

*OPTIONAL TEMPERATURE

SENSOR

		NC
	NO		C
* NOTE: Units with
		NC
an (Optional) Pump
	NO		C
Timer do not get an
(Optional) Temperature
Sensor

To change fan speed, move bottom wires on the speed select terminal block to the high, med-hi or med location.

JUMPER

24VAC THERMOSTAT CONNECTIONS						LINE	NEUTRAL
								GND
	R	W	C	Y	G

	24V
	120V	WARNING	NONC	com		HIGH	black	HIGH-MEDblue	MED	SelectSpeed
		1 AMP
TRANSFORMER									yellow
		MAX
		FUSE
2	1					Door Interlock
Continuous/Automatic						Switch		3	2
Ventilation Switch
								0	0
				red white blueorbrown	yellow	black
		FAN
		CAPACITOR

Note:

Unit is shipped on high speed.

PUMP

	CAF-01
FAN MOTOR	0101

29