Lightning Audio manual Design FeAtures, Storm S1.600D, Storm S1.1000D, Not Pictured

Design FeAtures

Storm S1.600D

	A		B		C	D	E	F
FRONT VIEW
			PASS
	SPEAKER		THRU
	OUTPUT
								JUICE
			RIGHT	LEFT	GAIN		CROSSOVER	BOOST
						SUBSONIC
			INPUTS			ON - OFF
G	H		I	J
+12V		+12V	FUSE

REM

POWERPOWERCELL

BACK VIEW

Storm S1.1000D

A	B	C	D	E	F
FRONT VIEW
	PASS
SPEAKER	THRU
OUTPUT
					JUICE
RIGHT	LEFT	GAIN		CROSSOVER	BOOST
			SUBSONIC
	INPUTS		ON - OFF

G	H	J
		I
+12V	+12V	FUSE
REM	REM
	GND
GND
POWER	POWERCELL

BACK VIEW

A.Speaker Connections: Follow correct polarity, and do not Ground any speaker wires. Do not connect any speaker wires together.

B.Pass Through Outputs: The Pass-Thru provides a convenient source for daisy-chaining an additional amplifier with- out running and extra set of RCA cables from the front of the vehicle to the rear amplifier location.

C.Gain Control: The input gain control is preset to match the output of most source units. They can be adjusted to match output levels from a variety of source units.

D.Sub-Sonic Filter: Variable from 10-50Hz

E.Adjustable Crossover Frequency Control: 50-250Hz.

F.Juice Boost: Applies 0-12dB of 50Hz Bass Boost.

G.Power Connector Plug: Connects Power, Ground, and Remote

H.Power Cell (Capacitor) Plug: Power Cell has 2 active leads for B+ and Ground.

I.Power Fuse: If this Fuse should blow, determine the cause or see your authorized dealer. Never replace the fuse with one of greater value than the original

J.RCA Input Jacks – Line Level from Radio Pre-outs:The industry standard RCA jack provides an easy connection for signal level input. They are gold-plated to resist the signal degradation caused by corrosion.

Not Pictured:

K.Juice Boost Remote Module: The Juice Boost remote module has a Green “Operation” indicator and Red “Protection” indicator. The Remote Juice Boost Module allows adjustment of the overall gain or volume of the amplifier. It operates only when the crossover switch is in Low Pass position. It does not alter the frequency response, but instead allows control of the overall gain of the amplifier driving your woofers. Most experienced users adjust the Juice Boost knob on the amp for the maximum desired amount of bass boost, and then plug in the module to control how much of that boost they want to unleash to their subwoofers.

- 3 -