Lightning Audio X1.800.4 Troubleshooting, Specifications, Symptom, Diagnosis, Remedy, turn on

Troubleshooting

Symptom	Diagnosis	Remedy
Amplifier does not	B+ or REM not between 10.5 and	Check the alternator, battery, fuse,
turn on.	15.5 volts or no voltage present	and wiring and repair as necessary
Amplifier Noise	Amplifier is not properly grounded.	Check wiring and repair as necessary
(Turn-On Pop)	Voltage spike from source unit is	Connect a relay turn-on module to
	entering amplifier’s input	REM terminal if pops are eliminated
		with no input signal to amplifier
Engine Noise	Noise is radiating into signal cables	Re-route signal cables away from
		sources of high current

Specifications

MODEL- Storm X1.1000.1D X1.2000.1D X1.400.2

Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts

X1.800.4

4Ω Load Per Channel	400 Watts x 1
2Ω Load Per Channel	700 Watts x 1
4Ω Load Bridged (Mono)
X1.1000.1D & X1.2000.1D Only
1Ω Load Bridged	1000 Watts x 1

Dimensions: -

add 1.5" (xcm) to length for mounting feet

Height	2.2" (5.6cm)
Width	10.4" (26.42cm)
Length	14" (35.56cm)

700 Watts x 1

1200 Watts x 1

2000 Watts x 1

2.2" (5.6cm)

10.4" (26.42cm) 22.0" (56.00cm)

100 Watts x 2

200 Watts x 2

400 Watts x 1

2.2" (5.6cm)

10.4" (26.42cm) 15.2" (30.61cm)

100 Watts x 4

200 Watts x 4

400 Watts x 2

2.2" (5.6cm)

10.4" (26.42cm) 18.6" (47.24cm)

Signal-to-Noise Ratio	>90dB A-weighted
Input Sensitivity	150mV - 4V
Crossover (X1.1000.1D & X1.2000.1D only)	24dB/octave Low Pass only
Crossover (X1.400.2 & X1.800.4 only)	24dB/octave HPF/Flat/LPF Switch
Crossover Frequency	variable from 50Hz to 250Hz
Channel Separation	50dB
Bass Equalization (X1.1000.1D & X1.2000.1D only)	Variable from 0dB to +12dB @ 20-80Hz

Specifications subject to change without notice

12