LightSpeed Technologies CAT 860 Ir Sensor/Receiver Isr Installation, Wall/Solid Ceiling Mount

5. Warranty, Safety & Specifications

2. IR SENSOR/RECEIVER (ISR) INSTALLATION

CONT’D

Once you find a suitable location for the ISR, follow these instructions to mount it. There are different instructions for mounting depending on if the ISR will be mounted to a suspended ceiling grid or secured to a wall / solid vertical surface.

2. IR SENSOR/RECEIVER (ISR) INSTALLATION

CONT’D

Wall/Solid Ceiling Mount

5. Warranty, Safety & Specifications

4. Troubleshooting

3. Optional Accessories

2. Setup & Use

1. Overview

Suspended Ceiling Mount

1.Attach the bracket to the ceiling tile grid (t-bar).

a.Slide the tabs onto the outsides of the t-bar, starting with one corner.

b.Attach the second tab around the other side of the t-bar.

c.Repeat with the other side of the bracket so it is connected at all four points.

2.Slide the ISR onto the bracket until it “clicks” into place.

a.Guide the mounting rails onto the bracket, oriented as pictured.

b.Once secure, the ISR locks into place.

c.To remove the ISR, press the release bar down and slide the ISR off the bracket.

3.Uncoil the Cat 5 sensor cable. Connect one end of the cable to the ISR. Secure wire overhead and route it back to the system.

4.Connect the other end of the Cat 5 sensor cable into the SENSOR INPUT jack on the CAT 860 amplifier.

clip connects to t-bar on ceiling

Release Bar

1.Screw the bracket to a place high on the wall or in the middle of the solid ceiling. Mount the bracket horizontally as shown above.

2.Uncoil the Cat 5 sensor cable. Connect one end of the cable to the ISR. Route the wire back to the CAT 860 amplifier, securing it along with way using surface raceway where possible.

3.Slide the ISR onto the bracket until it “clicks” into place.

a.Guide the mounting rails onto the bracket, oriented as pictured.

b. Once secure, the ISR locks into place.

c. To remove the ISR, slide a ruler or screwdriver behind the ISR to press the release bar down and slide the ISR off the bracket

4.Connect the other end of the Cat 5 sensor cable into the SENSOR INPUT jack on the CAT 860 amplifier.

4. Troubleshooting

3. Optional Accessories

2. Setup & Use

1. Overview

18 19