5. Warranty, Safety | & Specifications |
| |
|
|
4. Troubleshooting | |
|
|
|
|
3. Optional | Accessories |
11.USING THE REDMIKE TO AMPLIFY EXTERNAL AUDIO EQUIPMENT
The REDMIKE includes a 3.5mm audio input jack to connect to an audio source like a laptop or MP3 player. The REDMIKE will transmit the audio signal to be played through the system.
If your system includes two REDMIKEs, we recommend using Channel B (student mike) to amplify the external audio equipment so the teacher’s volume on the Channel A (teacher mike) does not have to be adjusted.
To determine which REDMIKE is set to Channel B, you can look at the switch on the back of the mike or speak into one of the mics and watch which set of LED’s glow on the front panel of the CAT 860 (A Volume or B Volume correspond to Channels A or B).
12. PAGEFIRST: PRIORITY MUTE
This optional feature interfaces with an independent classroom paging system. When the page is broadcast, all audio from the system is muted, ensuring important
How it works:
1. PageFirst sensor clip is hung around the lead wires attached to the classroom paging speaker.
2. The clip is
3. As a page is broadcast, the sensor clip detects the audio signal through induction and immediately mutes the CAT 860.
5. Warranty, Safety | & Specifications |
4. Troubleshooting | |
3. Optional | Accessories |
2. Setup & Use |
|
|
1. Overview |
1.Plug your external audio equipment (for example, laptop), into the input on the REDMIKE labeled “INPUT” using a 3.5mm patch cable.
AUDIO 
INPUT
4. When the page is over, the audio from the CAT 860 returns to normal volume level.
(For full installation details refer to the install sheet included with the optional PageFirst sensor clip)
2. Setup & Use |
|
|
1. Overview |
AUDIO
OUTPUT 
2. Adjust the volume on the CAT
860 receiver which corresponds to selected mic channel A or B.
28 | 29 |
