LightSpeed Technologies CAT 860 user manual LT-71 Charging, LT-71 Initial Set-up

5. Warranty, Safety	& Specifications
4. Troubleshooting
3. Optional	Accessories
2. Setup & Use
1. Overview

LT-71: Charging

1.Ensure that the LT-71 is turned OFF.

2.Make sure the cradle charger

is plugged into a wall outlet. Connect one end of the charging cable into the jack labeled CHARGER on the side of the LT-71 and plug the other end into the charging jack on the rear of the REDMIKE cradle charger. The LT-71’s rechargeable batteries are factory installed. The LED on the front of the LT-71 will glow RED when charging.

3.Leave the LT-71 plugged in overnight (8–10 hrs.) to obtain a full charge.

NOTE: If the system was purchased without a REDMIKE or REDMIKE VC, the LT-71 will utilize a charging cable. Simply connect the charging cables to the jacks labeled CHARGER on the back of the amplifier and connect the opposite ends to the jacks on the back of the cradle charger.

Front Panel		RS-232
1	Control Select		2
	+ -	- +		RS-232 IN

LT-71: Initial Set-up

Once the LT-71 is charged, follow these steps to set it up for use.

1. Turn the CAT 860 power switch to the ON position. The RED LED on the switch will glow.

2. Turn on the LT-71 and set the

operating channel to “B”.

3.Slip the LT-71 with lanyard around the neck and position the top of the microphone just below the

collarbone. NOTE: Positioning
of the LT-71 is critical for proper
volume adjustment.	LT-71

4. While speaking in a normal voice

slowly increase the volume for Channel B on the CAT 860 until your voice is barely audible.

REMEMBER: This equipment supplements the user’s voice so they are able to speak in a conversational tone. Having the volume set too high will result in feedback and listener fatigue.

3. Optional5. Warranty, Safety 1. Overview2. Setup & Use4. Troubleshooting Accessories& Specifications

74 75