5. Warranty, Safety | & Specifications | OPTIONAL IR MEDIA CONNECTOR AUDIO | |
INTEGRATION | |||
The iRMC is designed to integrate with the CAT 860 and multiple audio sources, | |||
|
| ||
|
| allowing other instructional technologies to be clearly heard throughout the | |
4. Troubleshooting | classroom. | ||
Video In | |||
ProjectoProjector | |||
| |||
|
| IR Sensor |
SECTION 4:
TROUBLESHOOTING
COMMON PROBLEMS AND SOLUTIONS
Note: Most problems are directly related to low battery power. Please run through the “Battery Check” items first. For remaining troubleshooting, use known good,
5. Warranty, Safety & Specifications |
|
|
4. Troubleshooting |
|
3.Optional Accessories |
|
| IR Transmission |
|
| Teacher’s | |
|
| Microphone | |
|
|
| |
| VGA Out |
| Audio Out |
|
|
| Speaker(s) |
& Use |
|
| Audio In |
|
|
| |
Setup | Video Out |
| Audio Out |
|
| iR Media Connector | |
2. |
|
| |
|
|
| |
| Video Out | DVD/VCR | Audio Out |
|
|
| |
|
|
| Cat855 |
1. Overview
OTHER OPTIONAL ACCESSORIES
IRMC | Infrared Media Connector |
|
|
|
|
Charging cable for REDMIKE Share and LT71 | |
|
|
6’ dual RCA audio cable | |
|
|
3.5mm to 3.5mm stereo audio cable |
ALL PROBLEMS: Most Problems are related to low battery power.
SOLUTION: Battery Check
•Confirm batteries are charged each night.
•Confirm proper batteries are used. The REDMIKE requires the Lightspeed
•Make sure the microphones are turned off while charging so a full charge is attained. Full charge will last eight hours.
•Inspect the battery contacts. Clean and adjust if necessary.
PROBLEM: Hearing Static
SOLUTION: Follow these steps to eliminate static.
•Ensure sensor is in optimum location (refer to sensor placement in manual). A single sensor will cover a 1600 sq. ft. enclosed classroom.
•Ensure that no other REDMIKE/LT-
71/REDMIKE Share is operating on the same channel.
•If the optional iR media connection is in use, set the microphone to Channel A.
PROBLEM: Low Volume or Feedback
SOLUTION: Follow these steps to eliminate low volume or feedback.
•Ensure microphone is positioned appropriately, just below the collar bone.
•Check volume level on the amplifier. If the volume is too high, feedback will occur. Adjust accordingly.
•Adjust the volume level on the back of the optional REDMIKE VC.
PROBLEM: No Sound From Speaker
SOLUTION: Follow these steps to produce sound from speakers.
•Turn the CAT 860 on. Confirm that the POWER light located on the front panel switch is on.
•Confirm signal is being received at the CAT 860. The IR signal light will be RED indicating a signal is being received.
•Confirm that REDMIKE is turned on. There will be a BLUE LED on the microphone to indicate it is powered on.
3. Optional Accessories |
|
|
2. Setup & Use |
|
|
1. Overview |
|
80
If you review these instructions and still have questions, write down the serial number and model number of your system and call Lightspeed Technical Services at 800.732.8999, 5 a.m. – 5 p.m., PST.
81