Safety Specifications |
REDMIKE Share: Controls and Connections
REDMIKE Share: Charging
Safety Specifications
5. Warranty, | & |
| |
|
|
4. Troubleshooting | |
|
|
|
|
3. Optional | Accessories |
| |
|
|
2. Setup & Use | |
| |
|
|
1. Overview |
2 3
1
4
5
1. | POWER SWITCH |
2. | POWER/CHARGE INDICATOR: |
1.Ensure that the REDMIKE Share is turned OFF.
2.Make sure the cradle charger is plugged into a wall outlet. Connect one end of the charging cable into the jack labeled CHARGER on the bottom of the REDMIKE Share.
3.Plug the other end into the charging jack on the rear of the cradle charger.
4.The LED on the microphone will glow RED to indicate charging.
5.Leave the REDMIKE Share plugged in overnight
3. Optional5. Warranty, 1. Overview2. Setup & Use4. Troubleshooting Accessories&
this light glows blue when turned |
on and turns off to indicate low |
battery level. When charging, the |
light glows red. |
3. AUDIO INPUT: plug a laptop, |
MP3 player or other audio device |
into this jack to wirelessly transmit |
the audio signal to be played |
through the system. |
4. CHANNEL SELECT SWITCH |
(CH A/B): Located in the battery |
compartment, this switch is set to |
Channel B at the factory. |
5. CHARGER INPUT: Plug the |
charging cable from the REDMIKE |
cradle charger or into this jack. |
NOTE: If the system was purchased without a REDMIKE or REDMIKE VC, the REDMIKE Share will utilize the charger jacks on the back of the CAT 860.
Front Panel |
|
| ||
1 | Control Select | 2 |
| |
+ - | - + | |||
|
|
|
|
76 | 77 |