Impinger I -–1000 Series Service Manual - Domestic 53
Type IV is 5 5/8 inches wide x 3 ¼ inches deep
Type IV has adjustment pots. In the center board.
If temperature is still inaccurate after above calibration and troubleshooting, use the following
to check the High Temp. Pot. normally the High Temp. Pot. does not require
adjustment. Occasionally the pot is accidentally moved or needs adjustm ent. Refer to the
following drawing showing proper adjustment of the High Temp. Pot.
test leads here
reading should be 26 ± .5 ohms if not, adjust.
pot. range 0-34 ohms
BOTTOM OF TIME TEMP DISPLAY
SWITCH, DISPLAY, SET
1. Shut off power at main bre aker.
2. Remove control panel to p.
3. Disconnect wires from time/temp. display terminals 5 and 6.
4. Pull off black operating k nob and remove hex mounting nut.
5. Reassemble in revers e order.
PROCEDURE FOR U SE OF TIME/TEMP. SIMULATOR
NOTE: DO NOT CHANGE HI TEMP POT.
4 7 9 10
TEST PROBES SHOULD
READ 18 OHMS
Check incoming power to display at Terminals 1, 2, and 3. Approximately 13 VAC at 1-3, 6.5
VAC at 1-2, 6.5 VAC at 2-3.
WithpowerOFF,removeleadsfrom4,5,6,7,8,9,and10.Installtime/temp.sim ulator to terminals 4,7,9,10.
To identify display type: (MEASURE WIDTH OF COVER ON DISPLAY)
Type I is 51/8 inches wide.
Type II is 5 5/8 inches wide.
Type I & II have a 6 position dip switch module.
Type III has a 10 position dip switch module.