Impinger I -–1000 Series Service Manual - Domestic50
SN 2164 AND ABOVE
1. Remove conveyor fr om oven and place on a flat work surface.
2. Remove connecting link s from conveyor belting. See Installation and Operating Instructions Manual .
3. Remove conveyor belt ing from conveyor
DRIVE END
4. Remove drive sprock et from drive shaft.
5. Remove two (2) allen he ad bolts.
6. Remove drive shaft and bearing assembly from conveyor frame.
7. Reassemble in revers e order.
IDLER END
4. Remove idler shaft/beari ng/mounting plate assembly from conveyor frame.
5. Remove bearing/m ounting plate assembly from conveyor.
6. Remove bearing from mounting plate.
7. Reassemble in revers e order.
TRANSFORMER-STEPPER MOTOR CONTROL
1. Shut off power at main bre aker.
2. Remove control panel to p and front cover.
3. Disconnect transform er wire harness.
4. Remove two (2) mounti ng screws.
5. Reassemble in revers e order.
HALL EFFECT SENSOR – REPLACEMENT
NOTE: There are two (2) styles of hall effect sensors - (See Drawing).
OLD STYLE
Remove two (2) screws from conveyor drive motor and break away hall eff ect sensor from motor shaft. To
install new sensor, cut sensor bracket through center hole and install sensor
half with one (1) screw. Reinstall plug on conveyor control.
NEW STYLE
Remove two (2) mounting screws and remove sensor from c onveyor motor. Reinstall in reverse order.
CUT
HERE DISCARD
OLD STYLE NEW STYLE