Heating Element Replacement | Lincoln II - Advantage Series guide

HEATING ELEMENT - REPLACEMENT

1.Shut off power at main breaker.

2.Remove back cover.

3.Disconnect heater element wires and mark for reassembly.

4.Disconnect motor wiring and mark for reassembly.

5.Remove oven back from oven.

6.Remove fan shroud.

7.Heater element may now be unbolted and removed.

8.Check heater elements to be sure they ar the proper replacement.

9.Reassemble in reverse order. Apply anti-seize compound to back bolt threads before reassembly.

NOTE: Be sure the lead terminals are tight. If the leads are not tight, a loose connection will result, causing arcing and lead wire burn off.

BEARING, CONVEYOR

1.Remove conveyor from oven and place on a flat work surface.

2.Remove connecting links from conveyor belting.

3.Move drive shaft or idle shaft toward end of conveyor, and shaft with bearing will now slip out of holding bracket.

4.Replace bearing and reassemble.

24	Impinger II – Advantage Service Manual - Domestic

Image 24

Lincoln II - Advantage Series service manual Heating Element Replacement, BEARING, Conveyor

Contents

Impinger Conveyor Ovens Table of Contents Sequence of Operations Impinger II Advantage Control BOX Auto Cool Down Heater Circuit Schematic 1116-000-A, 1117-000-A Schematic 1130-000-A / 1131-000-A Schematic 1132-000-A / 1133-000-A Troubleshooting Guide / GAS Ovens PhaseNatural GAS LP GASPage With Power on and Thermocouple Leads Attached to the Temperature ControlPage Page Troubleshooting Guide / Electric Ovens Single PhaseThree Phase Refer to Proper Schematic for Identified Components With Power on and Thermocouple Leads Attached to the TemperaturePage Page REMOVAL, INSTALLATION, and Adjustment ON/OFF Switch ReplacementMOTOR, Main FAN FAN, Main Fuse Holder Replacement THERMOSTAT, Control BOX HI-LIMIT ReplacementBurner Blower Motor Replacement High Limit Thermostat Replacement Burner Transformer Replacement Thermocouple ReplacementThermocouple Measurement Chart Information Electronic Temperature Control Board Replacement Electronic Temperature Control Board CalibrationTemperature Control Potentiometer Replacement Heat Light Replacement Temperature Regulation Valve Replacement HOT Surface Ignitor ReplacementMain Burner Orifice Replacement Conveyor Control Potentiometer Replacement Conveyor Control Board Replacement Conveyor Drive Motor ReplacementConveyor Control Board Calibration Circuit Breaker Hall Effect Sensor Replacement Temperature Display Transformer ReplacementTemperature Display Replacement Calibration of Temperature Display Heating Element Replacement BEARING, Conveyor This page intentionally left blank Parts / General Letter Part Number Description Blow UP / General Parts / Control BOX 1116-000-A, 1117-000-A Blow UP / Control BOX 1116-000-A, 1117-000-A Parts / Control BOX 1130-000-A Thru 1133-000-A Blow UP / Control BOX 1130-000-A Thru 1133-000-A Parts / Conveyor & Door Blow UP / Conveyor & Door Parts / Oven Back Assembly Blow UP / Oven Back Assembly