STATUS |
|
|
LIGHTS | CONDITION | SUGGESTIONS |
|
|
|
SAFETY | It is possible that this light could turn on | If machine can be reset, it is OK to continue |
| when power is first applied to machine. | operation. |
| The torch assembly is misconnected or | Check torch connection to machine. |
| damaged. |
|
| The shield cup assembly is not in place. | Securely fasten shield cup assembly in place. |
|
| By pressing reset, the machine will be |
| While cutting or gouging if the voltage | functional. This occurs most often when the |
| between the nozzle and the work is too | consumables are wearing out. By removing |
| high, it will put the machine into safety. | the hafnium that builds up on the inside of the |
|
| nozzle, it is possible to extend the life of the |
|
| consumables. |
| If the cable is punctured or cut, it can trip | By pressing reset, it will clear the SAFETY. |
| the SAFETY | When cutting is tried again, the machine will |
|
| either go into MALFUNCTION or SAFETY; |
|
| until that time, the machine will not indicate a |
|
| malfunction condition. |
|
|
|
|
|
|
|
|
|
– 21 –
