Lincoln Electric IM700-D manual Commander / K867 / LN-8 Connection Diagram

COMMANDER 300

COMMANDER / K867 / LN-8 CONNECTION DIAGRAM CONNECTION F-9

		WARNING
	Do not operate with panels open.			Keep guards in place.		DIAGRAM:
	Disconnect NEGATIVE (-) BATTERY LEAD			Keep away from moving parts.
	before servicing.			Only qualified personnel should install,use
	Do not touch electrically live parts.			or service this equipment.
		SPARE	}
		41
		82				LN-8
		81		N.C.		WIRE
		42				FEEDER
						DIAGRAMS
		31		31
	14 PIN	32		32
	AMPHENOL	2		2
		4		4
ELECTRODE	TO WORK	21		21	K196
	K867 UNIVERSAL
		GND		GND	INPUT CABLE
	ADAPTER PLUG
	TO WORK	75		A
	ELECTRODE CABLE	76		B
		77	}
	TO WIRE FEED UNIT			C

CAUTION :

N.D.

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE SELECTOR SWITCH TO "WIRE WELDING CV".

N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.D. SPLICE LEADS AND INSULATE.

7-2000	F-9
S23989