TROUBLESHOOTING | ||
| Observe all Safety Guidelines detailed throughout this manual |
|
|
|
|
ERROR CODES FOR THE POWER WAVE® S350
The following is a partial list of possible error codes for the POWER WAVE® S350. For a complete listing consult the Service Manual for this machine.
MAIN CONTROL BOARD ( “STATUS” LIGHT)
| Error Code # | Indication |
|
|
|
36 | Thermal error | Indicates over temperature. Usually accompanied by Thermal LED. |
|
| Check fan operation. Be sure process does not exceed duty cycle |
|
| limit of the machine |
|
|
|
54 | Secondary (Output) over current error | The long term average secondary (weld) current limit has been |
|
| exceeded. NOTE: The long term average secondary current limit is |
|
| 325 amps. |
|
|
|
56 | Chopper communication error | Indicates communication link between main control board and chop- |
|
| per has errors. If cycling the input power on the machine does not |
|
| clear the error, contact the Service Department. |
|
|
|
58 | Primary Fault error | Review error code from input board status light or status beeper. |
|
| Most likely caused by an over power condition which caused an |
|
| under voltage on the primary bus. If cycling the input power on the |
|
| machine does not clear the error, contact the Service Department. |
|
| |
Other | Error codes that contain three or four digits are defined as fatal | |
|
| errors. These codes generally indicate internal errors on the Power |
|
| Source Control Board. If cycling the input power on the machine |
|
| does not clear the error, contact the Service Department. |
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
POWER WAVE® S350
